REMOVAL

1. Remove the Evaporative Emission (EVAP) canister.

2. Remove the canister vent solenoid.

INSTALLATION

1. To install, reverse the removal procedure.

• Carry out the evaporative emission system leak test. See: Evaporative Emissions System\Testing and Inspection\Component Tests and General Diagnostics\Component Tests\Evaporative Emission System Leak Test
• Carry out the evaporative emission repair verification drive cycle. See: Evaporative Emissions System\Testing and Inspection\Component Tests and General Diagnostics\Component Tests\Evaporative Emission Repair Verification Drive Cycle

NOTE: Lubricate the O-ring seal with MERPOL(R) O-Ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144B.