Your Vehicle: 2001 Ford Escort ZX2 L4-2.0L DOHC VIN 3
 
Vehicle » Starting and Charging » Charging System » Testing and Inspection » Component Tests and General Diagnostics » Battery Tests » Using Alternator, Regulator, Battery and Starter Tester Method  
 
 
  Using Alternator, Regulator, Battery and Starter Tester Method  
 
  1. Connect the ARBST battery leads and press BATTERY TEST.

NOTE:

  • The BATTERY TEST AFTER CHARGE should only be used after the result CHARGE RETEST has been displayed and the battery has been recharged according to manufacturer's instructions.
  • The ARBST red load lead is equipped with a battery temperature sensor that provides diagnostic tailoring, based on battery temperature. In the event that the temperature sensor fails, the ARBST will prompt the operator to select a temperature range as follows:
  • (7) 0 degrees F (-18 degrees C)
  • (8) 32 degrees F (0 degrees C)
  • (9) 70 degrees F (21 degrees C)
  1. Enter the battery rating units and press ENTER.

NOTE:

  • The battery rating is usually printed on the battery label.
  • The battery rating units can be changed by selecting:
  • DIN
  • IEC
  • A-HR
  1. The display will read TEST IN PROGRESS, while the battery is loaded, released and then loaded again. The test will last approximately 50 seconds .
  2. Check the results:
    • GOOD BATTERY - The battery is good.
    • GOOD LOW CHARGE - Recharge the battery.
    • BAD BATTERY - Replace the battery.
    • CHARGE RETEST - Battery condition cannot be fully determined until it has been charged according to manufacturer's instructions. Once the battery is at a full state of charge then run BATTERY TEST AFTER CHARGE.