Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Engine, Cooling and Exhaust » Exhaust System » Technical Service Bulletins » Customer Interest » Exhaust System - Heat Shield Rattles  
 
 
  Exhaust System - Heat Shield Rattles  
 

Classification: EM10-003

Reference: NTB10-097

Date: August 23, 2010

EXHAUST HEAT SHIELD NOISE

APPLIED VEHICLES:
2002 - 2006 Altima (L31) with VQ35DE (V6) engine only
2007 - 2010 Altima Sedan (L32)
2008 - 2010 Altima Coupe (CL32)
2007 - 2010 Altima Hybrid (L32HV)
2004-2008 Maxima (A34)
2009 - 2010 Maxima (A35)
2004- 2009 Quest (V42)

IF YOU CONFIRM:

A noise is coming from the front exhaust tube heat shield(s) due to rattle.

ACTION:

Secure the heat shield(s) with new band clamps (see PARTS INFORMATION).

^ Refer to REPAIR PROCEDURE.

Do not replace the front exhaust tube for this incident, if it should occur.

IMPORTANT:
The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

  

PARTS INFORMATION

  

CLAIMS INFORMATION

SERVICE PROCEDURE

WARNING:
The exhaust system may be hot. Allow to cool down before inspection/repairs.

NOTE:
Exhaust system parts do not need to be removed for this inspection/repair.

1. Raise the vehicle on a hoist.

2. Inspect the heat shields on the front exhaust tube for the following:

^ Heat shield contact with the exhaust tube.

^ Separated / missing band clamp(s).

^ Weld separation(s).

3. If a heat shield is found contacting the exhaust tube, pry it away to allow a minimum 1 mm (.040 inch) space.

^ Road test the vehicle to verify the repair.

4. If a weld or band clamp is separated, or the band clamp is missing, install new band clamps as needed.

^ For band clamp(s) location, refer to the pictures below that applies to your vehicle.

  

5. Secure the band clamp with the hex bolt located on the side (or on top, if needed). See Figure 1 above for example.

WARNING:
Do NOT install the hex bolt on the bottom of the exhaust tube.

^ Band clamp hex bolt torque: 4.0 - 5.5 Nm (0.4 - 0.56 Kg-m, 2.9 - 4.0 ft-lb)

6. After securing the band clamp, cut off the clamp's excess at the end.

^ Wrap the end of the band clamp over the hex bolt, and then cut off the excess band clamp within 5 mm (0.2 inches) past the hex bolt (see Figure 2).

WARNING:
Be careful of sharp edges after cutting off the excess band clamp.

7. After band clamp(s) installation, road test the vehicle to verify the repair.