ALTIMA SEDAN, COUPE, AND HYBRID; ENGINE NO CRANK / NO START
APPLIED VEHICLES 2007 - 2010 Altima Sedan (L32) with CVT only
2008 - 2010 Altima Coupe (CL32) with CVT only
2007 - 2010 Altima Hybrid (L32HV)
IF YOU CONFIRM:
The engine will not crank (or go to READY MODE - Hybrid) when pressing the push-button ignition switch and applying the brake pedal.
ACCESSORY and IGNITION ON modes can be turned on and off during this condition.
Install a new brake lamp switch and sub-harness with those listed in PARTS INFORMATION.
For parts replacement and installation, refer to SERVICE PROCEDURE.
This bulletin does not apply to manual transmission equipped vehicles.
This bulletin does not apply to Hybrid vehicles with HEV related CONSULT-III DTCs.
This bulletin does not apply for this incident, should it occur, if ACCESSORY and IGNITION ON modes cannot be turned on.
Go back to ASIST and the Electronic Service Manual (ESM) for further diagnostic and repair information.
The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.