Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Powertrain Management » Computers and Control Systems » Testing and Inspection » Scan Tool Testing and Procedures » Trouble Diagnosis - Specification Value » Component Function Check  
 
 
  Component Function Check  
 

TROUBLE DIAGNOSIS - SPECIFICATION VALUE

Component Function Check

1.START
Check that all of the following conditions are satisfied.

  • Vehicle driven distance: More than 5,000 km (3,107 miles)
  • Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm2, 14.25 - 15.12 psi)
  • Atmospheric temperature: 20 - 30°C (68 - 86°F)
  • Engine coolant temperature: 75 - 95°C (167 - 203°F)
  • Transmission: Warmed-up
  • CVT models: After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" in "DATA MONITOR" mode of "CVT" system indicates less than 0.9 V.
  • M/T models: After the engine is warmed up to normal operating temperature, drive vehicle for 5 minutes.
  • Electrical load: Not applied
  • Rear window defogger switch, air conditioner switch lighting switch are OFF. Steering wheel is straight ahead.
  • Engine speed: Idle >> GO TO 2.

2.PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE:
Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.

  1. Perform " See: Programming and Relearning\Basic Inspection.
  2. Select "B/FUEL SCHDL", "A/F ALPHA-B1", "A/F ALPHA-B2" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
  3. Check that monitor items are within the SP value. Is the measurement value within the SP value?

YES >> Inspection END
NO >> Go to See: Diagnosis Procedure.