CONTROL VALVE

Inspection and Adjustment

Inspection AFTER REMOVAL
Check oil pan for foreign material.

• If a large amount of worn material is found, clutch plate may be worn.
• If iron powder is found, bearings, gears, or clutch plates may be worn.
• If aluminum powder is found, bushing may be worn, or chips or burrs of aluminum casting parts may enter. Check points where wear is found in all cases.

Inspection AFTER REMOVAL
Check the CVT fluid level and leakage. Refer to See: Fluid - CVT\Service and Repair\CVT RE0F10A.

Inspection AFTER INSTALLATION

Erase the TCM data.

• Erase the CVT fluid degradation level data using CONSULT-III. Refer to See: Testing and Inspection\Scan Tool Testing and Procedures\CVT RE0F10A\CONSULT-III Function (Transmission).
• Erase the memory of ROM using CONSULT-III. Refer to See: Testing and Inspection\Scan Tool Testing and Procedures\CVT RE0F10A\CONSULT-III Function (Transmission).