Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Transmission and Drivetrain » Continuously Variable Transmission/Transaxle » Service and Repair » CVT RE0F09B » Transaxle Assembly » Removal And Installation  
 
 
  Removal And Installation  
 

TRANSAXLE ASSEMBLY

Removal and Installation

REMOVAL

  1. Remove the engine and transaxle as an assembly. Refer to See: Engine, Cooling and Exhaust\Engine\Service and Repair.

NOTE:
Using paint, put matching marks on the drive plate and torque converter when removing the torque converter to drive plate nuts.

  1. Disconnect the electrical connectors from the following:
  1. Remove the harness from the transaxle.
  2. Remove the transaxle to engine and engine to transaxle bolts.
  3. Remove the CVT fluid charging pipe.
  4. Separate the transaxle from the engine.
  5. If necessary, remove the following from the CVT:
    • Fluid cooler tube
    • Air breather hose
    • Brackets

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:

  • When replacing an engine or transaxle you must make sure any dowels are installed correctly during re-assembly
  • Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of drive train components.
  • Do not reuse O-rings.
  • When turning crankshaft, turn it clockwise as viewed from the front of the engine.
  • When tightening the nuts for the torque converter while securing the crankshaft pulley bolt, be sure to confirm the tightening torque of the crankshaft pulley bolt. Refer to See: Engine, Cooling and Exhaust\Engine\Timing Chain\Service and Repair\Removal and Replacement.
  • After converter is installed to drive plate, rotate crankshaft several turns to check that CVT rotates freely without binding.
  • When installing the CVT to the engine, align the matching mark on the drive plate with the matching mark on the torque converter.

  

  • When installing CVT assembly to the engine assembly, attach the bolts in accordance with the following standard.