Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Steering and Suspension » Suspension » Testing and Inspection » Component Tests and General Diagnostics » Rear Suspension Assembly » Inspection  
 
 
  Inspection  
 

REAR SUSPENSION ASSEMBLY

Inspection

SHOCK ABSORBER ASSEMBLY

  • Check for smooth operation through a full stroke for both compression and extension.
  • Check for oil leakage on the welded or gland packing portions.
  • Check the shock absorber piston rod for cracks, deformation, or other damage and replace if necessary.

SUSPENSION ARM

  • Check the suspension arm for damage, cracks, deformation and replace if necessary.
  • Check the rubber bushings for damage, cracks and deformation. Replace suspension arm if necessary.

  

  • Check the ball joint. Replace the suspension arm assembly if any of the following conditions exist:
  • Ball stud is worn.
  • Joint is hard to swing.
  • Check if the swinging force (A), rotating torque (B), or vertical end play (C) is out of specification using Tool.

Tool number : ST3127S000 (J-25765-A)

NOTE:
Before checking specifications, turn the ball joint at least 10 revolutions so the ball joint is properly broken in.

  

RADIUS ROD

FRONT LOWER LINK

  • Check the front lower link for any deformation, cracks, or damage and replace if necessary.

UPPER AND LOWER RUBBER SEATS

  • Check the upper and lower rubber seats for deterioration, or cracks and replace if necessary.

REAR LOWER LINK AND COIL SPRING

  • Check the rear lower link and coil spring for any deformation, cracks, or other damage and replace if necessary.

STABILIZER BAR

  • Check the stabilizer bar and clamps for any deformation, cracks, or damage and replace if necessary.
  • Check the rubber bushings for deterioration, or cracks and replace if necessary.