Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Body and Frame » Technical Service Bulletins » Customer Interest » Interior - Front Seat Cushion Trim Unhooked  
 
 
  Interior - Front Seat Cushion Trim Unhooked  
 

Classification: BT09-031

Reference: NTB09-100

Date: September 28, 2009

2007 - 2009 ALTIMA; MANUAL FRONT SEAT CUSHION FRONT TRIM UNHOOKED

APPLIED VEHICLES:
2007 - 2009 Altima (L32, CL32, & L32HV) Sedan, Coupe, & Hybrid equipped with manual front seat(s).

IF YOU CONFIRM

  

The trim at the front of the seat cushion (left or right) is unhooked.

ACTION

1. Install metal clips on the front trim "J" hook.

^ Metal clips are listed in the Parts Information.

2. Re-engage the front trim "J" hook.

NOTE:
^ This bulletin applies to manually operated seats only.

^ Driver seat is shown, the passenger seat is similar.

IMPORTANT:
The purpose of ACTIONS (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing this repair.

  

PARTS INFORMATION

  

CLAIM INFORMATION

SERVICE PROCEDURE

1. Move the seat to the full rearward position and, if applicable, full up position.

  

2. Fold the front of the seat trim "up" to expose the front of the metal seat pan and the "J" hook (see Figure 2).

3. Install 2 metal clips on the "J" hook as shown in Figure 2.

^ Use metal clips listed in the parts information.

^ Center the clips with the 2nd cut-out on each end of the seat pan as shown in Figure 2.

  

^ Make sure the metal clips are fully installed (bottomed out) on the "J" hook.

  

4. Fold the front trim under the front of the seat pan to engage (re-hook) the "J" hook.

5. Enter and exit the vehicle (sit on the seat) a few times to make sure the front seat trim stays hooked.