REAR PARCEL SHELF FINISHER

Removal and Installation

REMOVAL

1. Release seatback latch RH/LH, then fold both rear seatbacks to forward most position.
2. Remove the clips, then remove rear seatback latch cover.
3. Lift seatback release cover, release the tabs and remove seatback release escutcheon from rear parcel shelf finisher.
4. Remove high mounted stop lamp (if equipped). Refer to See: Trim Panel\Service and Repair\Removal And Installation\Sedan.
5. Remove rear pillar finisher RH/LH. Refer to See: Trim Panel\Service and Repair\Removal And Installation\Sedan.
6. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf finisher.
7. Remove the clips, then remove rear parcel shelf finisher.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.