REAR REGULATOR
Removal and Installation
REMOVAL
- Remove the rear door finisher. Refer to See: Body and Frame\Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Sedan.
- Remove the plastic vapor barrier, being careful not to tear/damage it.
- Temporarily reconnect the power window switch to the door harness.
- Operate the power window switch to raise/lower the door window until the glass mounting bolts (A) can be seen.
- Remove the door glass bolts (A).
- Raise up the door glass and hold with a suction lifter (A).
- Disconnect the window motor connector.
- Remove the window regulator bolts (A) and remove the window regulator from the rear door panel.
INSTALLATION
Installation is in the reverse order of removal. Reset Limit Switch after Installation: See: Windows\Testing and Inspection\Programming and Relearning\Setting of Limit Switch
- After installation, inspect and adjust as necessary.
|
