Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Sensors and Switches » Sensors and Switches - Brakes and Traction Control » Steering Angle Sensor » Service and Repair  
 
 
  Service and Repair  
 

STEERING ANGLE SENSOR

Removal and Installation

CAUTION:
In the case that the ABS actuator and electronic unit (control unit) is replaced, make sure to adjust position of steering angle sensor. Refer to See: Brakes and Traction Control\Antilock Brakes / Traction Control Systems\Testing and Inspection\Programming and Relearning\Description See: Brakes and Traction Control\Antilock Brakes / Traction Control Systems\Testing and Inspection\Programming and Relearning\Special Repair Requirement See: Testing and Inspection\Description See: Testing and Inspection\Special Repair Requirement.

REMOVAL

  1. Remove the spiral cable. Refer to See: Restraints and Safety Systems\Air Bag Systems\Clockspring Assembly / Spiral Cable\Service and Repair.

  

  1. Remove the two screws (A) and release the three clips (B) to remove the steering angle sensor (1) from spiral cable (2).

INSTALLATION
Installation is in the reverse order of removal.