Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B2605 » Sedan With Intelligent Key  
 
 
  Sedan With Intelligent Key  
 

B2605 PNP SWITCH

Description
BCM confirms the shift position with the following 4 signals.

  • CVT selector lever
  • P/N position switch
  • P position signal from IPDM E/R (CAN)
  • P position signal from TCM (CAN)

DTC Logic

DTC DETECTION LOGIC

NOTE:

  

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON under the following conditions and wait for at least 1 second.
    • CVT selector lever is in the P or N position
    • Do not depress the brake pedal.
  1. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure
1.CHECK DTC WITH IPDM E/R
Check "Self diagnostic result" with CONSULT-III. Refer to See: Testing and Inspection.
Is the Inspection result normal?
YES >> GO TO 2
NO >> Repair or replace malfunctioning parts.
2.CHECK PNP SWITCH CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect TCM harness connector and BCM harness connector.

  

  1. Check continuity between TCM connector and BCM harness connector.

  

  1. Check continuity between TCM harness connector and ground.

  

Is the Inspection result normal?
YES >> GO TO 3
NO >> Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Refer to See: Testing and Inspection\Initial Inspection and Diagnostic Overview\Service Information For Electrical Incident\Intermittent Incident.
>> Inspection End.