Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Engine, Cooling and Exhaust » Engine » Compression Check » Testing and Inspection  
 
 
  Testing and Inspection  
 

COMPRESSION PRESSURE

On-Vehicle Service

CHECKING COMPRESSION PRESSURE

  1. Run the engine until it reaches normal operating temperature.
  2. Turn the ignition switch to OFF.
  3. Release fuel pressure and leave the fuel pump electrically disconnected. Refer to See: Fuel Pressure\Testing and Inspection.
  4. Remove all six spark plugs. Refer to See: Spark Plug\Service and Repair.

  

  1. Attach a compression tester to No. 1 cylinder.
  2. Depress accelerator pedal fully to keep the electric throttle control actuator butterfly-valve wide open to maximize air intake flow.
  3. Crank the engine and record the highest gauge indication.
  4. Repeat the measurement on each cylinder (steps 5 - 7).
    • Always use a fully-charged battery to obtain specified engine speed.

  

  1. If compression in one or more cylinders is low:
    1. Pour a small amount of engine oil into cylinders through the spark plug holes.
    2. Retest compression (steps 5 - 8).
    • If adding oil helps raise compression pressure, then the piston rings may be worn or damaged. If so, replace piston rings after checking piston.
    • If the pressure stays low, a valve may be sticking or is seating improperly. Inspect and repair the valve and/or valve seat. Refer to See: Camshaft\Specifications. If the valve and/or valve seat is damaged excessively, replace as necessary.
    • If compression stays low in two or more cylinders that are next to each other:
    • The cylinder head gasket may be leaking.
    • Both cylinders may have valve component damage. Inspect and repair as necessary.