Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Powertrain Management » Computers and Control Systems » Relays and Modules - Computers and Control Systems » Technical Service Bulletins » All Technical Service Bulletins » Engine Controls - ECM VIN Registration Procedure  
 
 
  Engine Controls - ECM VIN Registration Procedure  
 

Classification: EC09-028

Reference: NTB09-136

Date: December 1, 2009

2005 AND LATER; ECM VIN REGISTRATION

APPLIED VEHICLES: All Nissan 2005 and later

SERVICE INFORMATION

The Applied Vehicles must have the correct Vehicle Identification Number (VIN) registered in the Engine Control Module (ECM). The VIN registration process must be performed under the following conditions.

^ When installing a new ECM

^ If, during vehicle service, the VIN registration inside the ECM is found to be missing or incorrect.

When needed, use the Service Procedure in this bulletin to perform ECM VIN registration.

CLAIMS INFORMATION

Refer to the current Nissan Warranty Flat Rate Manual and use the appropriate claims coding for any repairs being performed.

SERVICE PROCEDURE

1. Connect C-III to the vehicle and perform the initial selections:

NOTE:
If C-III is already connected, go to Step 2.

a. Start C-III and Wait for the "Detecting VI/MI in progress" message to clear.

b. Select the detected VI from the list.

c. Wait for the "Checking the firmware version" message to clear.

d. Select Model and Year.

e. Confirm the correct model and year were selected.

f. Select Repair.

  

2. Select Direct Diagnostic Mode icon

  

3. Select System Diagnosis

  

4. Select Engine

5. Select OK

  

6. Select Work Support

  

7. Select VIN Registration

8. Select Next

  

9. Make sure the ignition is ON with engine OFF.

10. Select Start

  

11. Enter the VIN into C-III two times (see Figure 7).

^ Touch the C-III screen in the "VIN box" before typing.

^ Make sure to use all CAPITAL LETTERS.

^ Use the VIN from the vehicle you are working on.

12. Select Start

13. Turn the ignition OFF, and wait 10 seconds.

14. After waiting 10 seconds, turn the ignition ON.

  

15. Select OK

VIN registration is complete