DIAGNOSIS AND REPAIR WORK FLOW

CONFIGURATION (BCM) : Special Repair Requirement

1. WRITING MODE SELECTION CONSULT-III Configuration

Select "CONFIGURATION" of BCM.
When writing saved data>>GO TO 2
When writing manually>>GO TO 3

2. PERFORM "WRITE CONFIGURATION - CONFIG FILE" CONSULT-III Configuration

Perform "WRITE CONFIGURATION - Config File".
>> Inspection End.

3. PERFORM "WRITE CONFIGURATION - MANUAL SELECTION" CONSULT-III Configuration

1. Select "WRITE CONFIGURATION - Manual selection".
2. Identify the correct model and configuration list. Refer to See: Configuration List.
3. Confirm and/or change setting value for each item.
4. Select "Setting change".

CAUTION:
Make sure to select "Setting change" even if the indicated configuration of brand new BCM is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.

5. When "COMMAND FINISHED", select "END". >> GO TO 4

4. OPERATION CHECK Confirm that each function controlled by BCM operates normally.

>> Inspection End.