Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Powertrain Management » PROM - Programmable Read Only Memory » Technical Service Bulletins » All Technical Service Bulletins » Engine Controls - Blank ECM Programming Procedure » After Programming Has Completed  
 
 
  After Programming Has Completed  
 

After completing ECM programming, the following steps are required before C-III plus will provide the final programming confirmation report:

1. Follow the C-III plus on-screen instructions to perform the following:

^ Throttle Valve Closed Position

^ Idle Air Volume Learn (IAVL)

NOTE :

> Listed below are common conditions required for IAVL to complete.

> If IAVL does not complete within a few minutes, a condition may be out of range.

> Refer to the appropriate Electronic Service Manual (ESM) for specific conditions required for the vehicle you are working on.

^ Engine coolant temperature: 70 -105°C (158 - 221°F)

^ Battery voltage: More than 12.9V (At idle)

^ Selector lever: P or N

^ Electric load switch: OFF (Air conditioner, headlamp, rear window defogger)

^ Steering wheel: Neutral (Straight-ahead position)

^ Vehicle speed: Stopped

^ Transmission: Warmed up

^ Accelerator Pedal Close Position Learning

^ Erase DTCs

  

2. Verify the before and after part numbers are different (see Figure 21a).

3. Print a copy of this screen (Figure 21a) and attach it to the repair order.

4. Select Confirm.

5. Select Home and return to the C-III plus home screen.

6. Go to Verify VIN is Registered.