Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Body and Frame » Doors, Hood and Trunk » Front Door » Service and Repair » Sedan With Intelligent Key  
 
 
  Sedan With Intelligent Key  
 

DOOR

FRONT DOOR : Removal and Installation

CAUTION:

  • When removing and installing the front door assembly, support the door with a jack and cloth to protect the door and body.
  • When removing and installing front door assembly, be sure to carry out the fitting adjustment. Refer to See: Adjustments\Sedan With Intelligent Key.
  • After installing, apply touch-up paint (the body color) onto the head of the hinge nuts.
  • Check the hinge rotating parts for lubrication. If necessary, apply "body grease".
  • Operate with two workers, because of its heavy weight.
  • Check front door open/close operation after installation.

REMOVAL

  1. Pull the grommet and wire harness out of the front pillar until the harness connectors are accessible. Then disconnect the wire harness connectors.
  2. Remove the check link bolt from the front pillar.
  3. Remove the door-side hinge nuts (a) and the door assembly (1).

  

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
Adjust the door. Refer to See: Adjustments\Sedan With Intelligent Key.