Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
Vehicle » Windows and Glass » Front Door Window Glass » Service and Repair » Removal And Installation  
  Removal And Installation  


Removal and Installation


  1. Remove the front door finisher. Refer to See: Body and Frame\Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Coupe.
  2. Remove the bolt hole covers.
  3. Remove the door module assembly bolts and remove the upper window regulator bolts.


  1. Reconnect the window switch to raise/lower the door glass until the door glass bolts (A) can be seen.
  2. Remove the door glass bolts.


  1. While holding the door glass, raise it at the rear end to pull the door glass out of the sash toward the outside of the door.

Installation is in the reverse order of removal. Reset Limit Switch after Installation: See: Windows\Testing and Inspection\Programming and Relearning\Setting of Limit Switch

Inspection After Installation

  • Check that the door glass is securely set into the glass run groove.
  • Lower the door glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in) ] and check that the clearance to the sash is parallel. If the clearance between the door glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and door glass and guide rail bolts to correct the glass position.